Mikado Logo 600 SX User Manual Page 1

Pyro 650-103L, 550SX Edition Modifying the Logo 550SX to fit the Kontronik Pyro 650-103L

Step Four- Install Motor

Step Five- Adjust your settings and go fly! • Please adjust your throttle settings per the new gear ratio and motor kV. (the motor kV is 1030) • Enjo

Parts Needed • Mod 1, 106T Main Gear- MIK4621 • Mod 1, 11T or 12T Pinion- MIK4635 or MIK4636 – Note: the above parts are for the 600SX, which has a th

Step One- Cut Motor Shaft The motor shaft on the Pyro 650-103L needs 8mm removed from the end. This is to prevent the shaft from damaging and interfer

Step One- Cut Motor Shaft • Always protect the motor from metal particles. • Add chamfer to end of shaft.

Step Two- Install Mod 1 Main Gear • If you have previously installed the Mod .7 main gear in your 550SX, please remove it along with the counter beari

Step Two- Install Mod 1 Main Gear

Step Three- Install new bearing in Counter Bearing Support • The counter bearing support on the motor side is used on both the 550SX and 600SX models.

Step Three- Install new bearing in Counter Bearing Support • Insert the new bearing (6x13x5) in the existing location and press until fully seated.

Step Four- Install Motor • Loosely install the pinion on the motor shaft and install into the frame with the counter bearing support. Follow the Logo